Filter
Top Products
32
6 Finalizing and Erasing
3
- COMPACT DISC MULTI CHANGER
COMPACT DISC DIGITAL RECORDER
COMPACT DISC RECORDER / MULTI-CD CHANGER
Hi-bit Legato Link Conversion
CD TEXT
◊ÛB¿ˆ≤≥
ERASE
4
1
¡
¢
6 7
REC VOL
PUSH ENTER
¶
When a finalized disc is loaded:
1 Press ERASE.
2 Use the jog dial (or press 41 or
¡¢) to change the erase option.
Switch between:
• Erase the TOC (‘de-finalize’ the disc so that further
recording is possible)
FINALIZE
ERASE TOC ?
CD-RW
Be careful: When you erase the TOC, the CD text
information for the disc is also copied to memory for editing
purposes, erasing the oldest text information stored (as
explained on page 30).
• Erase all tracks
ERASE ALL ?
FINALIZE
CD-RW
• Press 7 to cancel erase here.
3 Press 6 (CD-R side).
The display shows the time remaining to completion.
• You can halt this erase process by holding down the 7
button for 10 seconds. Make sure, however, that you erase
the disc completely at a later date since you can’t use a
partially erased disc.
4 Eject the disc.
You must eject, then re-insert the disc if you want to record
any new tracks.
Re-initializing a disc
1 Press and hold ERASE for about four
seconds.
The display indicates initialize mode.
INITIALIZE ?
CD–RW
• Press 7 to cancel initialize here.
2 Press 6 (CD-R side).
The process takes about half the length of the disc. The
display shows the time left to completion.
• You can halt this erase process by holding down the 7
button for 10 seconds. Make sure, however, that you erase
the disc completely at a later date since you can’t use a
partially erased disc.
3 Eject the disc.
You must eject, then re-insert the disc if you want to record
any new tracks.