Filter
Top Products
29
5 Recording Features
Setting the balance
You can increase the relative volume of the right or left channel for
both recording and playback. However, It is generally not necessary
to change the balance of a commercially recorded source.
1 Make sure the recorder is stopped,
then press REC MODE.
The recorder goes into record-pause.
2 Press MENU/DELETE.
3 Turn the jog dial until BALANCE
appears in the display, then press to
ENTER.
4 Adjust the balance using the jog dial
(1 and ¡).
You can adjust the balance from 0dB (default) to around
-5dB in either direction.
• Pressing the jog dial (ENTER) and holding for 3 seconds
resets to center position.
5 Press the jog dial (ENTER) to confirm
the balance.
1 Prepare for recording
REC MODE must be pressed before going to step 2. See
pages 19–22 for step-by-step recording instructions.
2 Press CHECK to start the CD playing.
The track/disc to be recorded starts playing and the SCAN
indicator starts blinking.
3 Press the REC VOL. knob to adjust
the current recording level.
You see the current setting. If the FIX indicator lights, it
means the fixed setting is on, and you cannot change the
level. Press the REC VOL. knob again to turn it off.
Use the level meter to gauge the best recording level (the
loudest sounds in the source should reach no higher than
the 0dB mark on the meter; the red segments in the level
meter should not light at all.
To fix the recording level at your setting, press the REC
VOL
. knob again (the FIX indicator lights).To reset the
recording level to zero, hold down the REC VOL. knob for
three seconds.
4 When you’re satisfied with the
recording level, press CHECK again.
TIME
ENTER
MENU/
DELETE
1
¡
CHECK
3 - COMPACT DISC MULTI CHANGER
COMPACT DISC DIGITAL RECORDER
COMPACT DISC RECORDER / MULTI-CD CHANGER
Hi-bit Legato Link Conversion
CD TEXT
◊ÛB¿ˆ≤≥
REC MODE
MENU/
DELETE
REC VOL
PUSH ENTER
¶