Pioneer HTZ-FS30DVD-AP Home Theater System User Manual


 
Getting started 04
17
En
English
FrançaisDeutsch
Nederlands
Italiano Español
Chapter 4
Getting started
Setting Speaker Layout
Not applicable to the HTZ-FS30DVD/
HTZ-FS30DVD-AP model
Select the speaker layout for the speaker
setting you arranged to your listening area
environment.
First time you switch on the system, the
following speaker layout setting appears. If you
switch off the system without finishing this
setting, the same appears again next time you
switch on the system.
1 Press
STANDBY/ON
and confirm
WELCOME is shown on the display.
2 SELECT SPEAKER LAYOUT will run on
the display for about 10 seconds.
3Use / to select appropriate speaker
layout.
The speaker layouts you can select vary with
the model to be used.
See the Setup Guide for more details about
speaker layout and mode description.
5 SPOT – Optimal for 5.1 channel home
theater sound by placing the two surround
speakers in the rear of the listening position.
4 SPOT (HTZ585DVD-AP only) – This is
the standard layout for listening to the
surround sound, which is similar to the 5
spot speaker layout. The two center
speakers are separated to the right and left
sides, and neatly arranged around the TV.
3 SPOT – This is the classic layout for the
Front Surround mode. The two surround
speakers are placed in front of the listening
position.
2 SPOT (HTZ585DVD-AP only) – This
layout for the Front Surround mode is the
same as the 3 spot speaker layout. The two
center speakers are separated to the right
and left sides, and neatly arranged around
the TV.
4 Press ENTER to confirm.
1
Using the Auto MCACC setup for
optimal surround sound
Not applicable to theHTZ-FS30DVD/
HTZ-FS30DVD-AP model
The Multichannel Acoustic Calibration (MCACC)
system measures the acoustic characteristics of
your listening area, taking into account ambient
noise and testing for channel delay and channel
level. After you have set up the microphone
provided with your system, the receiver uses the
information from a series of test tones to
measure reverb, optimizing the speaker settings
and equalization (Acoustic Calibration EQ) for
your particular room.
2
Important
These test tones are loud; however, do not
turn the volume down during setup as this
may result in a sub-optimal calibration.
Make sure the mic and speakers are not
moved during the MCACC setup.
Note
1 To change the setting, press SHIFT+SETUP, use / to select SYS SET, then use / to select LAYOUT to start setting
procedure.
2 You only need to use the Auto MCACC setup once (unless you change the placement of your speakers or your room layout).
1
USB REC
PLAYLIST
OPEN/CLOSE
AUDIO SUBTITLE
ADAPTER PORT
USB
LINE
TUNER
(
FM/AM
)
DVD/CD
STANDBY
/ON
23
456
1
2
3
TOP MENU
TUNE
TUNE
MCACC
MENU
RETURN
SETUP
AUTO/
STEREO
SOUND
RETRIEVERSURROUND
SOUND
PRESET PRESET
HOME
MENU
ENTER
ECHO
KARAOKE
VOLUMECHANNEL
INPUT
SHIFT VOLUME
MUTE
T.EDIT
HTZ585DVD_EN.book 17 ページ 2009年3月19日 木曜日 午後6時35分