Filter
Top Products
Additional information 13
57
En
English
FrançaisDeutsch
Nederlands
Italiano Español
Resetting the system
Use this procedure to reset all system settings
to the factory default.
1 With the system on, press
SHIFT+SETUP
.
2Use
/
to select INITIAL then press
ENTER.
3Use
/
to select ALL INIT then press
ENTER
.
• INIT OK is displayed.
4 Press
ENTER
while INIT OK is blinking.
1
Using the language code list
Some of the language options (see Language
settings on page 36) allow you to set your
preferred language from any of the 136
languages in the Language code list below.
1 Select ‘Other Language’.
2Use
/
to select either a code letter or
a code number.
3Use
/
to select a code letter or a code
number.
See the Language code list below for a
complete list of languages and codes.
STEREO • STEREO appears when SURROUND or AUTO/STEREO is pressed in the TUNER,
LINE or ADAPTER PORT input mode.
KEYLOCK • The key lock is enabled. See Setting the Key Lock on page 52.
USB ERR • See Important in Using the USB interface on page 31 for more on this.
HDMI ERR • See HDMI connection above for troubleshooting tips. See also Resetting the HDMI
connection on page 42 if the problem persists.
EEP ERR • Contact your Pioneer authorized service center or your dealer for servicing.
EXIT • Appears when any prohibited signal is input or the headphones are connected
while the menu screen is displayed, and then the display returns to the normal
display.
NO MIC
• Appears when you press SHIFT
+KARAOKE, SHIFT+ECHO, SHIFT+, SHIFT+ or
MIC VOL +/– when no mic is inserted.
OC ERR 1
OC ERR 2
• Check whether the speaker cables are short-circuited. If the error message
continues to be displayed, contact your Pioneer authorized service center or your
dealer for servicing.
OVER TEMP • Try lowering the volume. If this problem is not fixed by removing and inserting the
power cable, this unit may be damaged. In such an event, please contact a Pioneer-
authorized service center or your nearest dealer.
BT ERR • Power consumption by Bluetooth ADAPTER is too high to supply the power.
Reconnect the Bluetooth ADAPTER.
TV AUDIO • Indicator is lit for two seconds if the listening mode is changed while HDMI audio
mode is set for TV.
KARAOKE • Appears when you press SURROUND, SOUND, AUTO/STEREO or MP3 EXP/
V.ENH when a mic is inserted.
PHONESIN • Appears when you press SURROUND, SOUND, AUTO/STEREO or MP3 EXP/
V.ENH when a headphone is inserted.
Message Description
Note
1 Do not operate the unit without reason or pull the power cord because the system’s power automatically turns on.
HTZ180_181_280_282DVD_En.book 57 ページ ２００９年３月１３日 金曜日 午後２時５０分