Filter
Top Products
Adjusting initial settings
Initial settings lets you perform initial setup of
different settings for this unit.
1 Function display
Shows the function status.
1 Press and hold SOURCE to turn the
source off.
2 Press FUNCTION and hold until the
clock appears in the display.
3 Press FUNCTION to select one of the in-
itial settings.
Press FUNCTION repeatedly to switch be-
tween the following settings:
ClockFM (FM tuning step)AM (AM tuning
step)AUX (auxiliary input)Dim (dimmer)
CONT (display contrast)P/O (RCA output)
D.ATT (digital attenuator)Mute (tele-
phone muting/attenuation)E.SCL (ever
scroll)
Use the following instructions to operate each
particular setting.
# To cancel initial settings, press BAND.
# You can also cancel initial settings by holding
down FUNCTION until the unit turns off.
Setting the clock
Use these instructions to set the clock.
1 Press FUNCTION to select clock.
Press FUNCTION repeatedly until clock ap-
pears in the display.
2 Push Multi Control left or right to select
the segment of the clock display you wish
to set.
Pushing Multi Control left or right will select
one segment of the clock display:
HourMinute
As you select segments of the clock display
the segment selected will blink.
3 Push Multi Control up or down to set
the clock.
Pushing Multi Control up will increase the se-
lected hour or minute. Pushing Multi Control
down will decrease the selected hour or min-
ute.
Setting the FM tuning step
The FM tuning step employed by seek tuning
can be switched between 100 kHz, the preset
step, and 50 kHz.
1 Press FUNCTION to select FM.
Press FUNCTION repeatedly until FM appears
in the display.
2 Push Multi Control left or right to select
the FM tuning step.
Pushing Multi Control left or right will switch
the FM tuning step between 100 kHz and 50
kHz. The selected FM tuning step will appear
in the display.
Initial Settings
En
45
English
Section
11