Filter
Top Products
12
<DRC1129>
En
NOTES:
÷
To insert the magazine, align its guide on the left side with the rail
inside the Changer.
÷
When inserting the magazine into the changer, insert it gently. If
it is pushed in violently, the discs in the magazine may be
projected, causing malfunction or disc damage.
If certain quantity of discs are projected from the magazine, the
built-in sensor of the unit is activated to stop the mechanism
operation and error code
“E83”
is displayed on the mode indicator.
In this case, remove the magazine, check that no disc is projected
from it, (correct projected discs if there is any) and turn the power
on again.
÷
The blinking of
“U”
or
“L”
on the display indicates that same
magazines are not loaded properly. In this case, load them again
properly.
÷
If only the
“-”
part of
“OPU-L”
is blinking, a disc may be projected
from a magazine. In this case, unload the magazine, insert discs
properly and load the magazine back in the Changer.
6. Close the front door.
÷ The display shows “- - - - -” and the mechanism starts to be
initialized.
7. Turn the key to the LOCK position.
÷ The key can be taken out at the LOCK position.
÷ Now the control from the host computer is possible again.
NOTE:
The initialize element status refers to storing whether each disc is
present in the magazine. When the discs have been inserted with the
above method, they are still not invalid; be sure to initialize the disc
information with any of the following methods.
Initialized Elements Status methods
There are three methods for issuing commands from the host
computer;
÷ issuing the WRITE BUFFER command;
÷ issuing the INITIALIZE ELEMENT STATUS command, and;
÷ issuing the MOVE MEDIUM command then transporting each
disc to the disc so that the TOC is read.
HOW TO INSTALL OR EXCHANGING DISCS
Method for setting the Function switch to
auto-initialize mode.
1. Insert the key into the Key switch and turn it to
the UNLOCK position.
÷ The DOOR OPEN button lights up.
2. Press and hold the DOOR OPEN button for more
than 4 sec.
÷ The blinking “OP” appears on the mode indicator and the
mechanism is initialized in this period.
÷ After initialization, the front door opens.
3. Set Function switch 1 to on.
÷ When the door is closed, installation starts automatically.
÷ For the disc installation and exchanging methods, please refer to
page 10.
Tip:
The auto-initialize mode has been set to off when the unit left the
factory.
)
OPEN/CLOSE
TT
TTT
DOOR OPEN
0
1
2
3
45
6
7
8
9
LOOK
UNLOOK
POWER
MAIL SLOT
DRIVE 4
DRIVE 3
DRIVE 2
DRIVE 1
ESC
ENT
LOCK
UNLOCK
Do not transport or move the unit with discs loaded inside it;
if discs drop out inside the unit, malfunction or disc damage
may result.
1
2
3
4
5678
ON
Function switch 1
Push this silver
plate.