Filter
Top Products
35
Music Server Play
Display and indicators
FORM 1
FORM 2
qSource name
wBit rate indicator
eTrack number
rPlaylist file name
tPlay time
yTrack title
Basic operation
It is possible to play back tracks recorded on
the music server.
1. Press SOURCE to select the music serv-
er.
Press SOURCE until “Music Server”
appears.
2. Press VOLUME to extend the VOLUME
outward.
• When you press VOLUME, it extends out-
ward so that it becomes easier to turn. To
retract VOLUME, press it again.
3. Turn VOLUME to adjust the volume.
4. Press
55
or
∞∞
to select a playlist file.
5. Press
22
or
33
to select a track.
Pressing 3 skips to the start of the next
track.
Pressing 2 once skips to the start of the cur-
rent track. Pressing again will skip to the
previous track.
• If you press and hold 2 or 3, you can per-
form fast forward or reverse.
Note:
• If no music is recorded on the music server, “No
audio” is displayed.
• If the music server cannot operate properly, an
error message such as “ERROR-30” is displayed.
Refer to “Understanding music server error mes-
sages” on page 79.
• When ACC ON/OFF is performed during internal
processing, “Processing” may be displayed. In this
case, please wait until the display goes out.
Selecting the playlist mode
The playlist mode uses playlist files that group
tracks according to the recording conditions at
the time of recording. The mode allows you to
play back only desired groups of tracks.
1. Press BAND to select the desired playlist
mode.
Press BAND repeatedly to switch between
the following modes:
All (each recording date) = Digital (digital
recordings) = Analog (analog recordings)
= Artist (artist) = Custom (custom)
Note:
• If you switch to playlist mode when nothing has
been recorded, “No PlayList” or “No audio” is dis-
played.
ry
qe t
rt
qwe