Filter
Top Products
Adjusting initial settings
1 Press OFF and hold until the unit turns
off.
2 Press MULTI-CONTROL and hold until
CLOCK SET appears in the display.
3 Turn MULTI-CONTROL to select one of
the initial settings.
CLOCK SET (clock)—OFF CLOCK (off clock)—
FM STEP (FM tuning step)—AUTO PI (auto PI
seek)—WARNING TONE (warning tone)—
AUX (auxiliary input)—SW CONTROL (rear
output and subwoofer controller)—
EVER SCROLL (ever scroll)—TITLE SETTING
(multi language)
# You can also perform the sameoperations by
pushing MULTI-CONTROL upor down.
# To cancel initialsettings, press BAND/ESC.
Setting the clock
Use these instructions to set the clock.
1 Use MULTI-CONTROL to select
CLOCK SET.
2 Press MULTI-CONTROL to display the
setting mode.
# Press BACK to return to the previous display.
3 Press MULTI-CONTROL to select the seg-
ment of the clock display you wish to set.
Each time you press MULTI-CONTROL, one
segment of the clock display is selected.
Hour—Minute
As you select segments of the clock display,
the selected segment blinks.
4 Turn MULTI-CONTROL to put a clock
right.
# You can also perform the sameoperations by
pushing MULTI-CONTROL upor down.
Turning the off clock
display on or off
If the off clock display is turned on, the clock
appears on the display when the sources are
off.
1 Use MULTI-CONTROL to select
OFF CLOCK.
2 Press MULTI-CONTROL to turn the off
clock display on.
# To turn the off clock display off, press
MULTI-CONTROL again.
Setting the FM tuning step
Normally the FM tuning step employed by
seek tuning is 50 kHz. When AFor TA is on,
the tuning step automatically changes to 100
kHz. It may be preferable to set the tuning step
to 50 kHz when AF is on.
1 Use MULTI-CONTROL to select FM STEP.
2 Press MULTI-CONTROL to display the
setting mode.
# Press BACK to return to the previous display.
3 Turn MULTI-CONTROL to select the FM
tuning step.
Turning MULTI-CONTROL switches the FM
tuning step between 50 kHz and 100 kHz while
AF or TA is on. The selected FM tuning step ap-
pears in the display.
# You can also perform the sameoperations by
pushing MULTI-CONTROL upor down.
Note
The tuning step remains at 50 kHz during manual
tuning.
Initial Settings
En
27
English
Section
04