Filter
Top Products
2 Press a or b to turn AUX on or off.
Pressing a or b will turn AUX on or off and
that status will be displayed (e.g.,
AUX:ON).
Setting the rear output and
subwoofer controller
This units rear output (rear speaker leads out-
put and RCA rear output) can be used for full-
range speaker (R-SP:FUL) or subwoofer
(R-SP:S/W) connection. If you switch the rear
output setting to R-SP :S/W, you can connect
a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
Initially, the unit is set for rear full-range speak-
er connection (R-SP:FUL). When rear output is
connected to full range speakers (when
R-SP:FUL is selected), you can connect other
full range speakers (P/O :FUL) or a subwoofer
(P/O:S/W) to the RCA rear output.
1 Press FUNCTION to select R-SP.
Press FUNCTION repeatedly until R-SP ap-
pears in the display.
2 Press a or b to switch the rear output
setting.
Pressing a or b will switch between
R-SP:FUL (full-range speaker) and R-SP:S/W
(subwoofer) and that status will be displayed.
# When no subwoofer is connected to the rear
output, select R-SP:FUL.
# When a subwoofer is connected to the rear
output, set for subwoofer R-SP:S/W.
# When the rear output setting is R-SP:S/W,
you cannot operate the following procedure.
3 Press c or d to switch the subwoofer
output or rear output.
Pressing c or d will switch between P/O:S/W
and P/O:FUL and that status will be displayed.
Notes
! Even if you change this setting, there is no
output unless you turn the subwoofer output
on (refer toUsing subwoofer output on page
28).
! If you change this setting, subwoofer output
in the audio menu returnto thefactory
settings.
Saving the battery
consumption
Even when this unit is switched off, the micro-
computer inside still uses a small amount of
power in order to enable a quick restart.
Switching on the Power Save mode will pre-
vent the microcomputer from running unne-
cessarily, thereby saving the battery in your
vehicle.
! With Power Save mode on, you cannot in-
sert or eject a disc when power to the unit
is off. Press SOURCE to switch the unit on,
then try again.
Important
If the battery in your vehicle is disconnected the
Power Save mode is canceled. Turn on Power
Save again once the battery has beenrecon-
nected. If the ignition switch in your vehicle
doesnt have an ACC(accessory) position, it is
possible depending on theconnection method
that when Power Save is off, the unit will draw
power from the battery.
1 Press FUNCTION to select SAVE.
2 Press a or b to turn power save on or
off.
Initial Settings
En
32
Section
09