Filter
Top Products
Connecting up 02
7
En
English
FrançaisDeutsch
Nederlands
Italiano Español
Chapter 2:
Connecting up
Making cable connections
Make sure not to bend the cables over the top
of this unit (as shown in the illustration). If this
happens, the magnetic field produced by the
transformers in this unit may cause a
humming noise from the speakers.
Important
• Before making or changing any
connections, switch off the power and
disconnect the power cord from the AC
outlet.
Connecting audio components
The number and kind of connections depends
on the kind of component you’re connecting.
Follow the steps below to connect a CD player,
tape recorder, turntable or other audio
component.
1 Connect the analog audio outputs of your
CD player (or other component) to the CD
inputs on this amplifier.
Use a stereo RCA phono cable as shown.
TUNER
AUX
CD PHONO
L
R
GND
L
R
SIGNAL
CONTROL
OUT
TAPE
IN
PLAY
OUT
REC
R
L
AUDIO IN/OUT
OUT
R
L
AUDIO OUT
12
PLAY
OUT
IN
REC
3
Turntable
Tape deck, etc.
This amplifier
CD player, etc.
D6
A6_MY.book Page 7 Tuesday, November 14, 2006 10:19 AM