Filter
Top Products
Other connections06
20
En
Switching components on and
off using the 12 volt trigger
You can connect components in your system to
this receiver through a 12 volt trigger. If you
turn the power to a connected component on,
the power to this receiver is also turned on.
This receiver will not turn on if you turn a
connected component off while this receiver is
currently off.
1
• Connect the 12V TRIGGER jack of this
receiver to the 12V trigger of another
component.
Use a cable with a mono mini-plug on each
end for the connection.
Note
1 When this system is already on, switching the connected component on will have no effect (switching the connected compo-
nent off will have no effect in any case).
FM UNBAL
75
12V
TRIGGER
SPEAKER R
12V
TRIGGER
A6_KU.book 20 ページ ２００６年１１月１３日 月曜日 午後３時１分