Filter
Top Products
Connecting up02
8
En
Chapter 2:
Connecting up
Making cable connections
Make sure not to bend the cables over the top
of this unit (as shown in the illustration). If this
happens, the magnetic field produced by the
transformers in this unit may cause a
humming noise from the speakers.
Important
• Before making or changing any
connections, switch off the power and
disconnect the power cord from the AC
outlet.
Connecting audio components
The number and kind of connections depends
on the kind of component you’re connecting.
Follow the steps below to connect a CD player,
tape recorder, turntable or other audio
component.
1 Connect the analog audio outputs of your
CD player (or other component) to the CD
inputs on this receiver.
Use a stereo RCA phono cable as shown.
• Connect any other components (such as
an iPod
1
dock or a portable audio player) to
the AUX inputs in the same way.
Note
1 iPod is a trademark of Apple Computer, Inc., registered in the U.S. and other countries.
TAP E
AUX1
AUX2
CD PHONO
L
R
GND
L
R
CONTROL
FM UNBAL
75
AM LOOP
XM
IN
12V
TRIGGER
ANTENNA
IN
SIGNAL
IR
IN
PLAY
OUT
REC
OUT
OUT
R
L
AUDIO IN/OUT
OUT
R
L
AUDIO OUT
12
PLAY
OUT
IN
REC
3
Turntable
Tape deck, etc.
This receiver
CD player, etc.
D6
A6_KU.book 8 ページ ２００６年１１月１３日 月曜日 午後３時１分