Filter
Top Products
8
English
3139 115 21251
Preparations
Rear connections
The type plate is located at the rear of the
system.
A Power
Before connecting the AC power cord to the
wall outlet, ensure that the following are done;
– If your system is equipped with a Voltage
Selector, set the VOLTAGE SELECTOR to the
local power line voltage.
– All other connections have been made.
WARNING!
– For optimal performance, use only the
original power cable.
– Never make or change any connections
with the power switched on.
To avoid overheating of the system, a safety
circuit has been built in. Therefore, your
system may switch to Standby mode
automatically under extreme conditions. If
this happens, let the system cool down
before reusing it (not available for all versions).
B Antennas Connection
Connect the supplied AM loop antenna and FM
antenna to the respective terminals. Adjust the
position of the antenna for optimal reception.
AM Antenna
● Position the antenna as far as possible from a TV,
VCR or other radiation source.
SPEAKERS 6Ω
R
+
—
L
—
+
SUBWOOFER
OUT
AM
ANTENNA
FM
ANTENNA
LR
speaker
(right)
speaker
(left)
FM wire antenna
AM loop
antenna
B
C
AUX/CDR
A
AC power cord
VOLTAGE
SELECTOR
110V-
127V
220V-
240V
VOLTAGE
SELECTOR
220V-
240V
110V-
127V
pg 001-028_255_21-Eng 12/24/01, 10:55 AM8