Philips MX5000/37 Home Theater System User Manual


 
9
English
IMPORTANT!
Before connecting the AC power cord to the
wall outlet, ensure that all other connections have
been made.
Never make or change any connections with
the power switched on.
The type plate is located at the rear of the
system.
Connecting antennas
FM Indoor Antenna
Connect the supplied FM antenna to the FM (75 )
jack. Move the antenna in various directions until the
clearest signal is received.
Note:
Keep the antenna as far away as possible from the TV, VCR
or any radiation source to prevent unwanted noise.
FM Outdoor Antenna
For better FM reception, use a 75 ohm coaxial cable (not
supplied) to connect the system to an outdoor FM antenna
as shown.
GND AM
FM (75 )
AM Indoor Loop Antenna
The supplied high-performance AM loop antenna is
sufficient for good reception in most areas.
1 Connect the loop antenna’s wires to AM and GND.
2 Place the antenna in a location (for example, on a shelf or
window frame) that gives the best reception.
Note:
Keep the antenna as far away as possible from the entire
system, speaker cables, and the power cable to prevent
unwanted noise.
AM Outdoor Antenna
If the supplied AM loop antenna does not deliver sufficient
reception, use an outdoor AM antenna (not supplied).
Use an insulated wire more than 15 feet (5m) long. Strip
one end, and connect that end to AM.
String the antenna wire outdoors or indoors near a
window. For better reception, connect the GND terminal
to a reliable ground.
Connections
CONNECTIONS
LR
SURROUND
SUB
WOOFER CENTER
FRONT
LR
SPEAKERS 6
IN
OUT
IN
AUDIO
CDR
OUT
TV IN
VCR
SAT
S-VIDEO
OUT
MONITOR
OUT
SUB
WOOFER
PRE-OUT
OUT
IN
IN
VIDEO
RL
DVD
VCR
SAT
AUX
GND AM
FM (75 )
ANTENNA
DIGITAL
OUT
SAT
IN
OPTICAL