Filter
Top Products
14
English
8240 009 34241
CD Operations
IMPORTANT:
The lens of the CD player should never be
touched.
Playing a disc
This CD player plays Audio Discs including CD-
Recordables and CD-Rewritables.
¶ CD-ROM, CD-I, CDV, VCD, DVD or computer
CDs, however, are not possible.
1 Select CD source.
2 Press OPEN / CLOSE on
the top of the system to open
the CD compartment.
➜ OPEN is displayed when
you open the CD
compartment.
3 Insert a disc with the printed side facing up and
press down on OPEN / CLOSE to close the
CD door.
➜ READ is displayed as the CD player scans the
contents of a disc, and then the total number of
tracks are shown.
4 Press 2; to start playback.
➜ Current track number is displayed then
elapsed playing time of the track are displayed
during disc playback.
5 To interrupt playback press 2;. Press 2; again to
resume play.
➜ The display freezes and the current track
number flashes when playback is interrupted.
6 To stop disc playback, press 9.
Note: CD play will also stop when;
– the CD door is opened.
– the disc has reached the end.
– you select another source: TAPE, TUNER.
– you select to standby.
– you press the tape deck PLAY
2
key.
Selecting a different track
● Press ¡1 or 2™ once or repeatedly until the
desired track number appears in the display.
● If you have selected a track number shortly after
loading a disc or in the PAUSE position, you will
need to press 2; to start playback.
Finding a passage within a track
1 Press and hold down on ¡1 or 2™ (on the
remote control à or á ).
➜ The disc is played at high speed and low
volume.
2 When you recognize the passage you want,
release ¡1 or 2™ (on the remote control à
or á).
➜ Normal playback continues.
Note:
– During a disc program or if SHUFFLE/ REPEAT
active, searching is only possible within the same
track.
pg001-024_MME100_37-Eng 11/20/2003, 03:58 PM14