Filter
Top Products
English
17
Preparation
Setting the clock
After connecting MCM760 to the power supply,
set the clock first.
1 On the remote control, press and hold
DISPLAY/CLOCK until the clock time starts
flashing
➜ The display shows the set time
➜ 12:00 AM appears by default if you have not
set the clock
2 Press PROGRAM repeatedly to change
between 12-hour and 24-hour clock mode
3 Press à or á repeatedly to set the hour
4 Press ÉÅ to change to minutes setting, then
press à or á repeatedly to set the minutes
5 Press DISPLAY/CLOCK again to store the
setting.
➜ The clock will start working.
Helpful hints:
– The clock setting will be erased when the system
is disconnected from the power supply.
– The set will exit from the clock setting mode if
no button is pressed within 90 seconds.
Using the remote control
IMPORTANT!
– Always point the remote control directly
towards IR area.
Notes for remote control:
– First select the source you wish to
control by pressing one of the source select
keys on the remote control (for example
CD, TUNER).
– Then select the desired function (for
example
ÉÅ
,
4
,
¢
).
Inserting batteries into the remote
control
1 Open the battery compartment
2 Insert 2 batteries type R06 or AA into the
remote control with the correct polarity as
indicated by the "+" and "-" symbols inside
the battery compartment
3 Put back the compartment door
1
3
2
CAUTION!
– Remove batteries if they are
exhausted or will not be used for a long
time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances,
so they should be disposed of properly.
CD TUNER
REPEAT PROGRAM
TAPE A/B DISPLAY/CLOCK
SHUFFLE
TAP E AUX
STANDBY
TAPE REC USB REC USB DEL SNOOZE
PRESET
ALBUM
VOL
001-036_MCM760_37_Eng 2/16/2006, 20:1117