Philips MC-45 Stereo System User Manual


 
17
English
3139 115 20751
CD Operation
Disc Playback
a disc is loaded in the disc tray
the current selected disc tray is empty
the current selected disc tray is loaded
the disc tray is currently playing
To play all discs on the disc tray
Press PLAYÉ (ÉÅ ).
All the available discs will play once, then stop.
During playback, the selected disc tray, track
number and elapsed playing time of the current
track will appear on the display.
To play one disc only
Press one of the CD DIRECT 1/2/3 buttons
on the remote control.
The selected disc will play once, then stop.
To interrupt playback
Press PAUSEÅ (ÉÅ ).
The current track time flashing.
To resume playback, press PLAYÉ (ÉÅ )
again.
To stop playback
Press Ç.
To search for a particular passage during
playback
Press and hold à or á and release it when
the desired passage is located.
During searching, the volume will be reduced.
To select a desired track
Press í or ë repeatedly until the desired
track appears on the display.
If playback is stopped, press PLAYÉ (ÉÅ ) to
start playback.
Note:
In Shuffle mode, pressing
í
will cause the
player to skip only to the beginning of the current
track.
To skip to the beginning of the current
track during playback
Press í once.
To resume playback from the last
selected track
In CD stop or pause mode, press CD
RESUME on the remote control to start
playback again from where you have stopped.
Notes:
Resume will not be available if you have
changed the disc, opened the disc tray or
disconnected the system power supply.
Select CD RESUME in any other source mode
will only able to resume the last selected CD active
mode (for example, CD stop or playback).
To replace disc during playback
You are able to replace or load in disc into the
other two disc trays without interrupting current
playback.
While playback, press the CD OPENCLOSE
button of the inactive disc trays (refer to
Loading Disc).
If you press CD OPENCLOSE button of the
active disc tray, the disc will stop playing and the
disc tray will slide out.
Once the disc tray is opened, it will be
deselected.
Programming the disc tracks
Programming tracks is possible when playback is
stopped. Up to 40 tracks can be stored in the
memory in any order.
1 Load the desired discs on the disc trays (refer to
Loading Disc).
2 Press PROG to start programming.
PROGRAM will start flashing.
3 Press CD 123 or CD DIRECT 1/2/3 button
to select a disc.
4 Press í or ë repeatedly to select the desired
track.
5 Press PROG to store the track.
Repeat steps 35 to store other discs and tracks.
6 Press PLAYÉ (ÉÅ ) to start program
playback.
"PLAY PROGRAM" will be displayed.
To end programming without starting playback,
press Ç once .
The total number of tracks programmed and
the total playing time will appear on the display.
pg 001-030/C50-C70/37-Eng 3/7/01, 3:48 PM17