Philips MC-45 Stereo System User Manual


 
13
English
3139 115 20751
Basic Functions
IMPORTANT!
Before you operate the system, complete
the preparation procedures.
Plug and Play
Plug and Play allows you to store all available
radio stations automatically.
If Plug and Play has not been installed
1 When you turn on the system, "AUTO
INSTALL - PRESS PLAY" will be displayed.
2 Press PLAYÉ (ÉÅ ) on the system to start
installation.
"INSTALL" will be displayed and followed
by "TUNER" and then "AUTO".
PROGRAM will start flashing.
The system will search for all radio stations
on the FM band, then the AM band.
All available radio stations with sufficient signal
strength will be stored automatically.
The system will stop searching when all the
available radio stations are stored or when the
memory for 40 preset radio stations is used.
The last preset radio station will play when
Plug and Play is completed.
To reinstall Plug and Play
1 In Standby or Demonstration mode, press and
hold PLAYÉ(ÉÅ ) on the system until
"AUTO INSTALL - PRESS PLAY" is
displayed.
2 Press PLAYÉ (ÉÅ ) again to start installation.
All previously stored radio stations will be
replaced.
To exit without storing the Plug and Play
Press Çon the system.
Notes:
When the power is turned on, the disc tray may
open and close to initialize the system.
If you do not complete Plug and Play installation,
Plug and Play will be reinitiated the next time you
turn on the power.
If no stereo frequency is detected during
Plug and Play, "CHECK ANTENNA" will be
displayed.
During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode automatically.
-
-+
-
OPEN
STANDBY
-
ON
iR
VOL
AUX/CDR
PROG
PRESET
TAPE
SEARCH/TUNE
TUNER
DEMO STOPPAUSE
PREV
NEXT
REC
STOP
PLAY
BASS TREBLE
NEWS
-+
DIM
CD 123
pg 001-030/C50-C70/37-Eng 3/7/01, 3:48 PM13