Filter
Top Products
Problem Solution
Does not play back – Make sure there is a recording on the disc.
– Make sure the disc is not scratched or dirty. Replace or clean the disc.
– Make sure the disc has been inserted, printed side up.
– Check if the right disc type has been inserted: DVD-Video disc, DVD-R(W),
(Super) Video CD,Audio CD, CDR(W), MP3-CD or DVD+R(W).
– Make sure the region code of the DVD disc matches the DVD recorder
system.
– Parental Control is switched on, see chapter “Access control”.
– Make sure the correct programme number (channel number) for the
DVD recorder system has been selected on the TV set.
– Check if the connection cable between DVD recorder system and TV set is
properly connected.
– Wait until steamed up laser lens has cleared.
Chapter does not play/is skipped – The chapter is hidden. Read “Making a hidden chapter visible” on page 39 on
how to make the chapter visible.
DVD+RW disc does not play on other – If a recording is too short, it is possible that a DVD player cannot detect it.
DVD players Please pay attention to the following minimum recording times depending on
the different recording modes:
M1: 5 minutes, M2: 10 minutes, M2x: 13 minutes, M3: 15 minutes,
M4: 20 minutes, M6: 30 minutes, M8: 40 minutes
– On some DVD players DVD+RW recordings cannot be played.You can use
the following special function to solve this problem for certain DVD players.
However, please note that there is a risk that you can no longer play
the DVD+RW disc on other DVD players after this procedure.Therefore
apply this function with particular care.
1 Press OPEN/CLOSE / on the set to open the drawer.
2 Insert the disc in the tray, but do not close the tray.
3 Press the numerical button 2 on the remote control until the tray closes.
➜ The disc is modified.
00
If this fails to produce the desired result, repeat the procedure pressing the
numerical button 3 on the remote control.
00
To restore the disc to its original condition press the numerical button 1
on the remote control.
Other disc errors – If playback of a DVD+RW disc is not possible at all, you can try to repair it
for new recordings.All existing recordings on the DVD+RW disc will be
deleted.
1 Clean the DVD+RW disc.
2 Press OPEN/CLOSE / on the set to open the drawer.
3 Insert the DVD+RW disc in the tray, but do not close the tray.
4 Keep CLEAR on the remote control pressed until the tray closes.
➜ The DVD+RW is repaired for new recordings.
Troubleshooting
60
English