Filter
Top Products
14
3139 115 2xxx1
English
Optional Connections (continued)
IMPORTANT!
– The progressive scan video quality
is only possible when using Y Pb Pr
and a progressive scan TV is required.
– DO NOT connect both SCART
and Y Pb Pr to a TV, it may affect the
picture quality.
1 Use the component video cables (red/
blue/green - not supplied) to connect the
Junction Box’s Y Pb Pr sockets to the
corresponding component video input
sockets (or labelled as Y Pb/Cb Pr/Cr or
YUV) on the TV.
● Do not connect the SCART from
Junction Box to your TV.
2 To hear the TV channels through this
DVD system, use an audio cables (white/
red - not supplied) to connect AUX IN
sockets to the corresponding AUDIO
OUT sockets on the TV.
3 Proceed to pages 20~21 for detailed
Progressive Scan set up.
Connecting to a Progressive
Scan TV
If the FM reception is poor, you can use
an FM coaxial cable (not supplied) to
connect the FM 75Ω coaxial cable hidden
inside the back cover directly to the
outdoor FM antenna terminal.
1 Open the main DVD system’s back cover
by lifting up the cover from the bottom.
2 Unplug the FM pigtail antenna from the
FM 75Ω coaxial cable.
3 Connect the FM 75Ω coaxial cable to
one end of the FM coaxial cable which is
connected to the outdoor FM antenna
terminal.
Helpful Hint:
– Position the antennas as far as possible
from your TV, VCR or other radiation source
to prevent unwanted interference.
DIGITAL IN L AUX IN R COMPONENT VIDEO
Pr Pb Y
TO SUB-
WOOFER
VIDEO
AUDIO
OUT IN
TV
Junction box
Connecting to outdoor FM
antenna terminal
FM Antenna
3
2
1
1
2
FM pigtail
cable
001-049 HTS8000S-00-Eng 22/04/2005, 04:05 PM14