Filter
Top Products
30 EN
Update software through the
Internet
1 Connect your home theater to a home
network with a high-speed Internet access
(see 'Connect and set up a home network'
on page 14).
2 Press (Home).
3 Select [Setup], and then press OK.
4 Select [Advanced] > [Software update] >
[Network].
» If an upgrade media is detected, you are
prompted to start or cancel the update.
5 Follow the onscreen instructions to conrm
the update.
» Once complete, the home theater
automatically switches off and restarts. If
it does not, disconnect the power cord
for a few seconds and then reconnect it.
Update the onscreen help
If the current version of the onscreen help is
lower than the latest version available on www.
philips.com/support, download and install the latest
onscreen help (see 'Check software version' on
page 29).
What you need
• A USB ash drive that is FAT or NTFS-
formatted, with at least 35MB of memory. Do
not use a USB hard drive.
• A computer with internet access.
• An archive utility that supports the ZIP le
format.
Step 1: Download the latest onscreen
help
1 Connect a USB ash drive to your computer.
2 In your web browser, go to www.philips.com/
support.
3 At the Philips support website, nd your
product and click on User manuals, and then
locate the User Manual Upgrade Software.
» The help update is available as a zip le.
4 Save the zip le in the root directory of your
USB ash drive.
5 Use the archive utility to extract the help
update le in the root directory.
» A le named 'HTSxxxxeDFU.zip' is
extracted under the UPG_ALL folder
of your USB ash drive, 'xxxx' being the
model number of your home theater.
6 Disconnect the USB ash drive from your
computer.
Step 2: Update onscreen help
Caution
• Do not switch off the home theater or remove
the USB ash drive during the update.
1 Connect the USB ash drive containing the
downloaded le to your home theater.
• Make sure that the disc compartment is
closed and there is no disc inside.
2 Press (Home).
3 Enter 338 on the remote control.
4 Follow the onscreen instructions to conrm
the update.
5 Disconnect the USB ash drive from the
home theater.