Philips HTS3555 Home Theater System User Manual


 
45
English
Radio Operations
Before you start ...
Make sure the FM and AM/MW antennas
are connected.
Tuning to radio stations
A Press SOURCE repeatedly until ‘FM’
appears on the display panel (or press
RADIO on the remote control.)
B Press and hold W / X on the remote
control to start tuning.
ÎThe frequency indication starts to
change until a radio station with suf cient
signal strength is found.
C Repeat step B if necessary until you  nd
the desired radio station
D To  ne-tune the reception of a weak
station, press S / T brie y and
repeatedly until an optimal reception is
found.
Presetting radio stations
You can store up to 40 FM and 20 AM/
MW preset radio stations in the memory.
There are three different ways to
program the radio stations:
Using auto install (for  rst time setup
only)
Using automatic preset
Using manual preset
Helpful Hints:
– This unit exits presetting mode if no
button is pressed within 20 seconds.
– If no stereo signal is detected or less than
5 ( ve) stations are detected during radio
installation, ‘CHECK FM ANTENNA’ appears.
Using auto install
When you access the ‘RADIO’ mode for
the very  rst time, you will be prompted
to install the radio stations. With this
feature, you can install all the available
radio station automatically with one
touch of button.
RADIO
A Press RADIO.
Î ‘AUTO INSTALL ... PRESS PLAY’
appears.