Philips HTS3372D Stereo System User Manual


 
12
Option 2: Connect to the component
video jack
1 Connect the component video cable
(not supplied) to the Y Pb Pr jacks on
this Home Theater System and the
COMPONENT VIDEO input jacks on the
TV.
If a progressive scan TV is used, you
may turn on the progressive scan
mode. (see ‘Get started’ > ‘Turn on
Progressive Scan’).
Note
The component video input jack on the TV might be
labeled as Y Pb/Cb Pr/Cr or YUV.
This type of connection provides good picture
quality.
VIDEO OUT
PbPr Y
PbPr Y
Option 1: Connect to the HDMI jack
1 Connect an HDMI cable (not supplied)
to the HDMI OUT jack on this Home
Theater System and the HDMI input jack
on the TV.
Note
If your device supports HDMI CEC, you can control
compliant devices with a single remote control. (see
‘Get started’ > ‘Use Philips EasyLink’).
Tip
If the TV has a DVI connection only, connect via
a HDMI/DVI adaptor. Connect an audio cable for
sound output.
You can optimize the video output. (see ‘Adjust
settings’ > ‘Video setup’ > [HDMI Setup] ).
This type of connection provides the best picture
quality.
HDMI OUT
HDMI IN
EN
1_hts3371D-72D_F7_en 3.indd 12 4/30/2009 8:38:34 PM