Philips FW-V795 Stereo System User Manual


 
35
English
3139 115 21281
Troubleshooting
GENERAL
The system does not react when buttons Remove and reconnect the AC power plug and
are pressed. switch on the system again.
Sound cannot be heard or is of poor Adjust the volume.
quality. Disconnect the headphones.
Check that the speakers are connected correctly.
Check if the stripped speaker wire is clamped.
Make sure the MP3-CD was recorded within
32-256 kbps bit rate with sampling frequencies
at 48 kHz, 44.1 kHz or 32 kHz.
The left and right sound outputs are Check the speaker connections and location.
reversed.
The remote control does not function Select the source (VCD or TUNER, for example)
properly. before pressing the function button (É,í,ë).
Reduce the distance between the remote control
and the system.
Insert the batteries with their polarities
(+/– signs) aligned as indicated.
Replace the batteries.
Point the remote control directly toward
IR sensor on the front of the system.
The timer is not working. Set the clock correctly.
If a recording is in progress, stop the recording.
Not all lighted buttons are showing light. Press DISPLAY to select NORMAL or MODE 1
display mode.
The Clock/Timer setting is erased. Power has been interrupted or the power cord
has been disconnected. Reset the clock/timer.
The system displays features Press and hold DEMO STOP Çon the system
automatically and buttons start flashing. to switch off the demonstration.
pg 001-035/V795/21-Eng 4/16/02, 6:44 PM35