Filter
Top Products
10
English
3139 115 21281
3 Set the VOLTAGE SELECTOR to the local
power line voltage.
4 Plug in the AC mains to the wall socket.
5 Switch on the POWER SWITCH to activate
the power booster amplifier.
6 Press STANDBY ON button to switch the
system ON or to Standby mode.
7 Rotate the VOLUME control to adjust the
loudness of the power booster amplifier.
Inserting batteries into the
Remote Control
Insert two batteries (Type R06 or AA) into the
remote control with the correct polarity as
indicated by the + and - symbols inside the
battery compartment.
CAUTION!
– Remove batteries if they are exhausted
or not to be used for a long time.
– Do not use old and new or different
types of batteries in combination.
– Batteries contain chemical substances, so
they should be disposed off properly.
Preparations
pg 001-035/V795/21-Eng 4/16/02, 6:42 PM10