Philips FW-V28 Stereo System User Manual


 
3139 116 20021
17
English
TUNER
DIGITAL
SOUND
CONTROL
STANDBY
-
ON
PROGRAM DIM
VCD MINI HIFI SYSTEM
CD1 2 3 BAND
TAPE 1 2
TAPEVCD TUNER
AUX
PRESET
TUNING
STOPCLEAR
SEARCH
PLAY PAUSE PREV NEXT
D
B
B
VIDEO
O
P
T
I
M
A
L
J
A
Z
Z
R
O
C
K
T
E
C
H
N
O
DSC
RECORD
DUBBING A.REPLAY
VOLUME
MICROPHONE - LEVEL
PAL/NTSC
CLOCKTIMER
RETURN
PBC
Note:
For 'EASY SET' feature, please refer to
page 11.
Tuning to radio stations
1 Press TUNER (BAND) to select TUNER
mode.
TUNER will be displayed.
A few seconds later, the current radio
frequency will be displayed.
2 Press TUNER (BAND) again to select
the desired waveband : FM or MW.
3 Press à or á for more than one
second, then release.
The display will show SEARCH
until a radio station with sufficient
signal strength is found.
Repeat this procedure until the desired
station is reached.
To tune to a weak station, briefly press
à or á repeatedly until the display
shows the desired frequency and/or
when the best reception has been
obtained.
Storing Preset Stations
You can store up to 40 radio stations in the
memory. When a preset radio station is
selected, the preset number appears next
to the frequency on the display.
Automatic programming
1 Press TUNER (BAND).
2 Press PROGRAM for more than one
second.
The PROG flag starts flashing and
AUTO will be displayed.
The system will search for every
available station in the FM waveband
first, then search the MW waveband.
All available stations will be stored
automatically. The frequency and
preset number will be displayed
briefly.
The system will stop searching when
all the available radio stations are
stored or when the memory for 40
preset radio stations is used.
The system will remain tuned to the
last stored preset radio station.
Notes:
You can cancel the automatic
programming by pressing PROGRAM or
Ç
(on the system only).
If you want to reserve a section of
preset numbers, for example preset
numbers 1 to 9, select preset 10 before
starting automatic programming, only
the preset numbers 10 to 40 will be
programmed.
Manual programming
1 Press TUNER (BAND).
2 Press TUNER (BAND) again to select
the desired waveband : FM or MW.
3 Press PROGRAM for less than one
second.
The PROG flag starts flashing.
The next available preset number will
be displayed for selection.
4 Press à or á to tune to the desired
frequency.
If you wish to store the radio station to
another preset number, press 4 or 3 to
select the desired preset number.
5 Press PROGRAM again.
The PROG flag disappears and the
radio station will be stored.
Repeat
steps 3 – 5
to store other preset
radio stations.
Untitled-1 31/05/2001, 11:35 AM17