Filter
Top Products
English
7
POWER SUPPLY
Whenever convenient, use the mains supply if you want to conserve battery life.The battery
supply will be switched off when the set is connected to the mains.
Make sure you remove the plug
from the set and wall outlet before inserting batteries.
Batteries
1.Open the battery compartment and insert six batteries, type
R14, UM2 or C-cells,(preferably alkaline) with the correct
polarity as indicated by the "
+
" and "-" symbols inside the
compartment.
2.Replace the compartment door, making sure the batteries are
firmly and correctly in place.
3.Remove the batteries if they are exhausted or if they will not be used for a long period.
– Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment
or cause the batteries to burst.Therefore:
– Do not mix battery types, e.g. alkaline with zinc carbonate.
– When inserting new batteries, replace all at the same time.
Notes :
–The battery supply is switched off when the set is connected to the mains.
Batteries contain chemical substances,so they should be disposed of properly.
1.Check if the mains voltage as shown on the type plate (on the
bottom of the set) matches your local mains voltage.If it does
not, consult your dealer or service organization.
2.If your set is equipped with a voltage selector, adjust the
selector so that it matches with the local power supply.
3.Connect the mains lead to the AC MAINS
~ socket and the
wall socket.
™ The set is now ready for use.
4.To switch off the mains supply completely,pull the mains plug out of the wall socket.
™ Disconnect the mains lead when you change over to battery supply, or to protect the set
during heavy thunderstorms.
The type plate is located on the bottom of the set.
BATTERIES (NOT SUPPLIED)
MAINS
A
C
M
A
I
N
S
~
6 x 1.5V R14/ UM2/ C CELL
AZ6188_01_Eng(NEW) 4/22/04 16:52 Page 7