Philips AZ 6188 CD Player User Manual


 
21
English
TROUBLESHOOTING
Problem Solution
"NO DISC" is displayed Insert a disc and check if the disc is upside down.
Wait until the moisture condensation at the lens has
cleared.
Replace or clean the disc,see "Maintenance"
Use a readable disc or an MP3-CD recorded in the
correct format.
Radio reception is poor If the signal is too weak, adjust the antenna for better
reception.
Increase the distance between the Receiver and your
TV or VCR.
Recording or playback cannot be made Clean deck parts,see "Maintenance".
Use only NORMAL (IEC I) tape.
Apply a piece of adhesive tape over the missing tab
space.
The system does not react when the Slide the source selector to TAPE/OFF. Remove the
buttons are pressed /The set does not AC power plug and reconnect it 30 seconds later
work / No display on LCD. and then switch on the system again.
Sound cannot be heard or is of poor Adjust the volume.
quality Make sure the MP3-CD was recorded within 32-320
kbps (128kbps preferably) with sampling frequencies
at 8 - 48 kHz (44.1kHz preferably).
Loop,Follow or Compare is not available Check if the language learning mode is activated. Press
and hold MODE until LANG ON appears on the
display.Then the language learning is activated.
The set does not break sentences The CD disc may be scraped. Please replace the disc
automatically with a new one.
If in the tape mode,the tape quality may be poor.
Please use a good tape.
The playing speed cannot be changed The playing speed can be changed only in the
language learning mode.
Please activate Loop,Follow or Compare function in
the language learning mode first.
If a fault occurs,first check the points listed below before taking the set for repair.If you are unable
to remedy a problem by following these hints,consult your dealer or service centre.
WARNING:
Do not open the set as there is a risk of electric shock.Under no
circumstances should you try to repair the set yourself,as this will
invalidate the guarantee.
AZ6188_01_Eng(NEW) 4/22/04 16:52 Page 21