Pelco FR85011 Satellite Radio User Manual


 
16 C1642M-A (1/05)
CONNECTIONS
Connections to the FT85011 transmitter and the FR85011 receiver are made on the rear panel
of the modules and consist of the following:
Power connection
NOTE:
A 12 VDC or 24 VAC power supply can be used to power the transmitter/receiver
when used as a standalone module. A 12 VDC power supply is provided. If a 24 VAC
power supply is used, the power supply must be a Listed Direct Plug-In Power Unit
marked as Class 2 and rated as 24 VAC, 200 mA (minimum output).
Fiber connection
Data connection
•Video input connection (transmitter only)
•Video output connection (receiver only)
Figure 6 provides an illustration of FT85011 transmitter/FR85011 receiver connections.
Figure 6.
FT85011 Transmitter/FR85011 Receiver Connections
1
2
3
4
5
6
7
8
GND
0
1
2
3
4
5
6
7
8
9
POWER/ALARM CONNECTION
FOR RACK-MOUNTED MODULE*
POWER CONNECTION
FOR STANDALONE MODULE†
FIBER OPTIC CABLE
COAXIAL CABLE
DATA COMMUNICATION
CABLE (REFER TO TABLE B
FOR DATA CONNECTOR
PIN ASSIGNMENTS AND TO
FIGURES 7-12 FOR WIRING
DIAGRAMS)
*REFER TO THE RK5000PS-3U/RK5000-3U FIBER RACK MOUNT CHASSIS INSTALLATION
MANUAL FOR INFORMATION.
†THE STRIPED WIRE OF THE SUPPLIED 12 VDC POWER SUPPLY CONNECTS TO THE
PIN 1 SCREW TERMINAL (DC+) OF THE STANDALONE POWER CONNECTOR. THE
OTHER WIRE CONNECTS TO THE PIN 2 SCREW TERMINAL (DC-).
C1642M-AFT85011.bookPage16Wednesday,January19,200512:46PM