14 C1642M-A (1/05)
MOUNTING THE TRANSMITTER/RECEIVER INTO A RACK
Optional fiber rack mount chassis, which can be mounted into an industry-standard 19-inch
(48.26 cm) equipment rack, are designed for installation of multiple modules:
• The RK5000PS-3U fiber rack mount chassis provides 12 module slots and a power
supply.
• The RK5000-3U fiber rack mount chassis provides 14 module slots (a power supply is not
included). Power to the modules can be supplied using the optional external power
supply (EPS5000-120).
For additional information, refer to the RK5000PS-3U/RK5000-3U Fiber Rack Mount Chassis
Installation manual.
MOUNTING THE TRANSMITTER/RECEIVER TO A WALL
The FT85011 transmitter/FR85011 receiver can be mounted to a wall in the following ways:
• Using the supplied wall clip for attachment of a single module to a wall. For installation
instructions, refer to the
Mounting the Transmitter/Receiver Using the Wall Clip
section.
• Using the optional fiber wall mount kits for a maximum of three modules to be attached
to a wall. The optional WM5001-3U wall mount base kit allows attachment of a single
module to a wall. Up to two WM5001-3UEXP wall mount expansion kits can be used to
allow attachment of two additional modules to the wall. For additional information,
refer to the Fiber Wall Mount Kits Installation manual.
Mounting the Transmitter/Receiver Using the Wall Clip
NOTE:
Before mounting the FT85011 transmitter/FR85011 receiver to a wall, ensure
that there is adequate space at both ends for viewing the front-panel LEDs and for
making the various rear-panel cable connections.
To attach the FT85011 transmitter/FR85011 receiver to a wall using the supplied wall clip, refer
to Figure 5 and do the following:
1. Using the two vertical or horizontal wall-mounting holes, attach the wall clip to a wall
using two screws (not provided).
2. Slide the module into the clip until the two holes on the bottom of the module align with
the two holes on the lower flange of the clip.
3. Attach the module to the clip using the two Phillips pan head screws provided for the clip.
C1642M-AFT85011.bookPage14Wednesday,January19,200512:46PM