12 C1642M-A (1/05)
Installation
PACKAGE CONTENTS
The following items are supplied:
• With the FT85011 transmitter:
1 Regulated switching power supply with four plug adapters (North American,
Australian, U.K., and European configurations); 100-240 VAC input, 12 VDC output
1Wall clip with two 4-40 x .250-inch Phillips pan head screws with lock washers
(for attachment of single module to wall)
1 FT85011/FR85011 Fiber Transmitter and Receiver Installation manual (this manual)
• With the FR85011 receiver:
1 Regulated switching power supply with four plug adapters (North American,
Australian, U.K., and European configurations); 100-240 VAC input, 12 VDC output
1Wall clip with two 4-40 x .250-inch Phillips pan head screws with lock washers
(for attachment of single module to wall)
1 FT85011/FR85011 Fiber Transmitter and Receiver Installation manual (this manual)
DATA COMMUNICATION SETUP
NOTE:
As a matter of convenience, it is recommended that you set the desired data
communication before mounting the FT85011 transmitter/FR85011 receiver into a rack
or onto a wall.
The Data Selection switch, which is located on the rear panel of the FT85011 transmitter/
FR85011 receiver, is a 10-position rotary switch that allows you to set the data communication
required for the transfer of data (refer to Figure 4).
Figure 4.
Data Selection Switch
1
2
3
4
5
6
7
8
GND
0
1
2
3
4
5
6
7
8
9
0
1
2
3
4
5
6
7
8
9
DATA
SELECTION
SWITCH
C1642M-AFT85011.bookPage12Wednesday,January19,200512:46PM