Filter
Top Products
C2458M-F (4/11) 7
INSTALLING THE IPS-CABLE: 9-PIN SERIAL CONNECTION
To install the IPS-CABLE to computers with a 9-pin serial connection, refer to Figure 1 and perform the
following steps:
1. Connect a null modem cable (not supplied) to the COM1 or COM2 serial port on the computer.
2. Connect the 9-pin male connector from the IPS-CABLE (supplied) to the null modem cable.
3. Connect the IPS-CABLE to the RJ-45 port of the desired dome drive or IPS-RDPE-2.
NOTE: When connected, the IPS-CABLE will interrupt control from the normal control source.
Figure 1. IPS-CABLE Installation with 9-Pin Serial Connection
COM 1
COMPUTER
IPS-CABLE
OR
COM 2
CONNECT TO
COM 1 OR COM 2
ON COMPUTER
NULL MODEM CABLE
(NOT SUPPLIED)
DB-9
MALE
BNC CONNECTOR
TO VIDEO INPUT
ON MONITOR
RJ-45 PORT
OF SPECTRA
RJ-45 PORT
OF PS-RDPE-2
CONNECT
TO