Filter
Top Products
8
WARNING!
For optimum performance and reliability DO NOT PRESENT
THE AMPLIFIER WITH A SPEAKER LOAD OF LESS THAN
2 OHMS, OR A COMBINATION OF SPEAKERS THAT
TOGETHER ARE LESS THAN 2 OHMS!
Using one speaker, it must be rated at 2 ohms minimum.
Using two speakers, they must be rated each at 4 ohms minimum.
Using three speakers, they must be rated each at 8 ohms
minimum.
AVIS!
Pour assurer la Fiabilte et obtenit une performance optimale, ne
soumette jamais l'amplificateur a une charge d'impedance totale
inferieure a 2 ohms, ni avec un H.P. ni en combinaison des H.P.
AVEC un H.P., il Faut une charge d'impedance minimum de 2 ohms.
AVEC deux H.P., il Faut pour chaoun une charge d'impedance
minimum de 4 ohms.
AVEC trois H.P., il Faut pour chaoun une charge d'impedance
minimum de 8 ohms.
TM
STEREO MODE
To left speakers
DDT Compression
should be enabled for
system protection
Left Output
from Mixer
Right Output
from Mixer
Can be used as
outputs to chain to
other power amp
units
Mode switch must be
in stereo position
To right speakers
TM
BRIDGE MODE
System Load
4 ohm minimum
DDT Compression
should be enabled for
system protection
Output
from Mixer
Not Used
Mode switch must be
in bridge position
TM
TWO-CHANNEL MONO MODE
Connect to first
set of speakers
DDT Compression
should be enabled for
system protection
Output
from Mixer
Mode switch must be
in stereo position
Connect to second
set of speakers
Connect
Channel A
to Channel B