Filter
Top Products
7
CONNECTING YOUR JC 2
Always disconnect the AC cord to your JC 2 and power amplifier(s) before making or changing
any input, output or trigger wire connections. Inserting or removing an input or output cable
while the JC 2 or power amplifiers are turned on can result in a blast of sound that can damage
your loudspeakers. Make sure there is no strain or tension on any cables that could cause
them to pull loose.
INPUT CONNECTIONS
There are a total of six line level input jacks on your
JC 2. Input 1 and Input 2 include both Balanced XLR
and Unbalanced RCA connections.
Unbalanced RCA Input Jacks
All of the six unbalanced RCA inputs have the same
input sensitivity and impedance. These inputs are
compatible with any typical analog line level source.
When using the In 1 or In 2 unbalanced RCA input
connections, set the input’s corresponding Balanced/
Unbalanced selector switch to Unbalanced.
Balanced XLR Input Jacks
Use these inputs to connect any source components
with balanced outputs. A balanced line provides
superior hum and noise cancellation, especially for
long cable runs. Many serious listeners also prefer
the sonic characteristics of balanced interconnects
because the lower inherent noise floor contributes
to a more defined and spacious soundstage. When
using the balanced XLR input connections, set the
input’s corresponding Balanced/Unbalanced selector
switch to Balanced.