Filter
Top Products
CONNECTING THE AC POWER CORD
9
1
2
1
2
JC1 Amplifier
Parasound Products. Inc.
San Franscisco, CA USA
Ground
Normal
Lift
Fuse
T15A/250V-115V Area
T8A/250V-230V Area
Power Consumption: 1200W
AC 115V 60Hz
AC 230V 50Hz
AC Power Connections
We recommend that you plug your JC 1 into the same AC wall outlet or power strip that
powers your other audio components, especially the preamplier or system controller.
Having all the audio components on the same power circuit helps prevent hum caused
by possible ground loops. The JC 1 requires AC power that is continuous rather than
switched on and off.
What you’ll need:
An IEC 65 AC Cord (provided)
An AC outlet or high quality AC power strip within reach of the AC cord
Before Connecting
Remove power to all the components in your audio system.
To Connect
Plug the female end of the AC cord to the AC receptacle on the rear of the JC 1.
Plug the male end of the AC cord to an AC outlet or power strip.