Filter
Top Products
-5-
Caution
Be patient while loading the disc. Never try to load the disc before the holder has opened fully. Never
try to close the drawer before you are certain the disc is properly seated in the recess of the holder. If the
machine tries to withdraw the holder with the disc only partially in place, it may ruin the disc. A disc
that is warped may interfere with drawer operation. Do not try to play a warped disc.
Maintaining Your C/DP-1000
Your C/DP-1000 is made to provide years of faithful service. You should keep it dusted, but never use
any abrasives, solvents or treated rags which could harm the surface. The acrylic window over the
function display is quite easy to scratch.
• Try to avoid smoking nearby the player. The residue could easily get into the delicate optical parts.
• The same precautions apply to the remote controller.
• Since dust and dirt can cause problems, never turn off the C/DP-1000 with the disc drawer open.
Taking Care of Your Compact Discs
Be careful to handle discs only at their edges. For cleaning there are several CD cleaners available at
your Parasound dealer. Just remember to wipe gently from inside to out, never in a circular fashion as
you would an ordinary LP record. Never leave any discs lying around outside of their proper holders.
In Case of Difficulty
If you believe your unit is malfunctioning, please refer again to these instructions. It is quite easy to
confuse some of the programming functions until you become accustomed to them.
• Disc holder won’t close when disc has been inserted:
-discs are not placed properly in the holder
-disc is warped
• Disc is inserted, but display does not show number of tracks and playing time:
-disc was inserted upside down
-disc is dirty - clean it carefully
-disc is scratched or defective - try another disc
-there is condensation on the laser lens - allow to warm up and dry
• Sound skips or mistracks often:
-player is exposed to excessive vibration - find better location
• Program function will not operate:
-programming was erased - reprogram the memory
• Hum:
-a cable connection is loose - press cable plugs in tightly
-a cable could be defective - try another cable
• One channel not operative:
-check cable connections
-try another source at your preamp to confirm problem is with your CD player
• Remote control does not work:
-batteries in remote control are weak
-there is an obstruction between the remote control and player
-you are at too great an angle to player for remote signal to reach it
-there is no disc loaded in the player
-player is exposed to bright light which interferes with the remote signal