Filter
Top Products
-2-
A Note on Moisture Condensation and Dew
If your C/DP-1000 is brought directly from a cold location to a warm room or if it is placed in a very
damp room, moisture may condense on the laser lens within the unit. If this occurs, the player will not
operate. Remove the disc and leave the player in a warm, dry place for about an hour so the moisture
can evaporate.
Connecting Your C/DP-1000
Before making any connections, turn off the power on your power amplifier. This will avoid an
accidental “blast” of sound which could damage your speakers.
Use the cables supplied between the Analog Line Out jacks on your C/DP-1000 and any high level input
jacks on your preamplifier, amplifier or receiver marked CD, AUX or TAPE PLAY. Connect the Right
and Left channels according to their markings on both units.
You may connect the player directly to a power amplifier which has input gain controls, however you
may require the additional gain of a preamplifier to reach adequate listening levels.
You may prefer to try one of the premium audio cables which are available from your Parasound Dealer.
The benefits of these are debated among audio hobbyists, and we cannot guarantee you will find a
significant audible improvement.
Make certain that all your connections are secure and that there is no tension on the cables which could
cause them to pull loose in the future.
Plug the AC cord into any convenient outlet or the unswitched outlet on the rear panel of your
preamplifier or receiver. Try to run the AC cord in a perpendicular direction to the audio cables to
minimize hum.
Before you start to operate the system with your C/DP-1000 installed, turn down the volume on your
amplifier to a low setting. Read the remainder of these instructions.
External Remote Control Connector
Your C/DP-1000 accepts the input of any popular infrared repeater system to facilitate remote control
operation from another room or to preserve remote control operation if your player is installed within a
cabinet whose doors block signals from your remote control handset. This connector is a popular
3.5 mm mini jack and its center conductor is +, the outer is - . For further details contact your Parasound
Dealer or Custom Installer.
Digital Connections
Your C/DP-1000 is equipped with an RCA jack for 75 Ω coaxial connection to an external D-A con-
verter. You must use a digital cable which will minimize data reflections within the cable. You cannot
achieve satisfactory results with a conventional audio patch cord.
Advanced Digital Adapter Module (ADAM)
An optional Advanced Digital Adapter Module (ADAM) is available from your Parasound dealer. The
ADAM features the AT&T glass fiber ST module and the AES/EBU standard using a 3 pin XLR con-
nector. Either of these will provide superior sound if your D-A converter is equipped to accept them.
The advantage of the AT&T glass fiber optic connection is that it electrically isolates your player from
the rest of the system, with a potential for a lower noise floor. The AES/EBU output offers a balanced
output with a separate ground. It is very easy to install the ADAM yourself. Insure that the C/DP-1000
is unplugged before attempting to install the ADAM. Remove the two screws at either side of the cover
plate near the left side of the rear panel on your C/DP-1000.