Filter
Top Products
4. Press the key of the remote controller (“LD ” changes to “LP ” of the
LCD).
5. Set the laser power at 600 W±10% by using VOL+ and VOL- key of the
remote controller.
[Specified range: 600 W±10%]
Caution:
Proceeding on to the subsequent adjustment procedure with the read power
exceeding 600 W±10% will result in damage to the optical pickup.
6. Set the laser power with the key of the remote controller (“LP ” changes
to “LDOK ” in the LCD).
7. Press the key of the remote controller (“LDOK ” changes to “T0E ” on
the LDC.
8. Remove the laser power meter. Laser power adjustment is finished.
[REFERENCE]
<For use of MD cartridge type laser power meter>
We recommend you to use a sensor type laser power meter for laser power
adjustment of this set.
But if available is a MD cartridge type only, follow the procedure below.
1. Disassemble the unit so that only the mechanism unit and the printed circuit
board are exposed. (as shown in Fig. 8 )
2. Set the laser power meter cartridge. (as shown in Fig. 8 )
3. Set the battery and attach and secure the battery cover with a rubber band.
(as shown in Fig. 9 )
4. Follow the steps for “6.2.1. Enter the adjustment mode”. (Subsequent
procedures are the same as those for the sensor type.)
Fig. 8
29