Filter
Top Products
ENGLISH
9
RQT8043
RQTX0055
GETTING STARTED
■ Fitting speaker stands (not included)
(For center and surround speakers)
Ensure the stands meet these conditions before
purchasing them.
Note the diameter and length of the screws and the
distance between screws as shown in the diagram.
• The stands must be able to support over 10 kg.
• The stands must be stable even if the speakers are in a
high position.
■ Preventing the speakers from falling
• You will need to obtain the appropriate screw eyes to
match the walls or pillars to which they are going to be
fastened.
• Consult a qualifi ed housing contractor concerning the
appropriate procedure when attaching to a concrete
wall or a surface that may not have strong enough
support. Improper attachment may result in damage to
the wall or speakers.
String (not included)
Thread from the wall to the
speaker and tie tightly.
Rear of the speaker
Screw eye
(not included)
Wall
Approx.
150 mm
Speaker installation optionsSpeaker installation options
■ Attaching to a wall
You can attach all of the speakers (except subwoofer) to
a wall.
• The wall or pillar on which the speakers are to be
attached should be capable of supporting 10 k per
screw. Consult a qualifi ed building contractor when
attaching the speakers to a wall. Improper attachment
may result in damage to the wall and speakers.
• When mounting the front speakers to a wall, we
recommend using a string (not included) to prevent it
from falling.
2 Screws 2 Cover plates
Preparation for front speakers
1 Remove the speaker cable from the stand.
1 Release the cable
from the groove.
2
2 Connect the cable (\ page 8).
1 Attach the cover plate to the front speaker
Screw
Tighten securely.
Cover
plate
1
2
2 Drive a screw (not included) into the wall.
Ø7.5 to 9.5 mm
4.0 to 6.0 mm
Wall or pillar
Ø4.0 mm
3 Fit the speaker securely onto the screw(s) with the hole(s).
340 mm
Center speaker
200 mm
Surround speaker
106 mm
Front speaker
In this position, the
speaker will likely
fall if moved to the
left or right.
Move the speaker
so that the screw is
in this position.
Example:
Reattaching the speaker cable to the stand
1 Remove the eight screws from the stand, and remove the
speaker net.
Screw
2 Position the cable.
Approx. 15 cm
Press the speaker
cable into the
groove.
Cable
3 Attach the speaker net with the screws.
Metal screw holes
For attaching to
speaker stands
Speaker
stand
(not included)
5 mm, pitch 0.8 mm
Plate thickness plus
7 mm to 10 mm
60 mm
Example: Center speaker
RQTX0055-B_Out_new14.indd 9RQTX0055-B_Out_new14.indd 9 3/16/07 6:48:13 PM3/16/07 6:48:13 PM