Filter
Top Products
11
Simple Setup
Digital transmitter connection / AC cord connections / Preparing the remote control
11
RQTX0105
Conserving power
The main unit and the wireless system consume a small amount of
power when they are turned off (main unit: approx. 0.3 W, wireless
system: approx. 0.2 W). To save power when they are not to be used for
a long time, unplug them from the household AC outlet.
You will need to reset some memory items after plugging in the main unit.
[Note]
The included AC power supply cords are for use with the main unit and
wireless system only. Do not use them with other equipment. Also, do
not use cords for other equipment with the main unit or wireless system.
∫ Batteries
≥Do not heat or expose to flame.
≥Do not leave the battery(ies) in an automobile exposed to direct
sunlight for a long period of time with doors and windows closed.
Do not:
≥mix old and new batteries.
≥use different types at the same time.
≥take apart or short circuit.
≥attempt to recharge alkaline or manganese batteries.
≥use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
∫ Use
Aim at the remote control signal sensor (➜ 15), avoiding obstacles,
at a maximum range of 7.0 m (23 ft) directly in front of the unit.
step
4 Digital transmitter connection
TRANSMITTER
DIGITAL
Do not insert or remove while
the main unit is on.
Digital transmitter
Insert fully until you hear a click.
Main unit
step
5 AC cord connections
L
R
FM ANT
(75 )
P
B
Y
AUX
COMPONENT VIDEO OUT
R
P
VIDEO OUT
AC IN
LOOP ANT
G
AM ANT
EXT
LOOP
LOOP
OPTION V.1
AC IN
AC power supply cord
(included)
To household
AC outlet
(AC120 V, 60 Hz)
Main unitWireless system
To household
AC outlet
(AC120 V, 60 Hz)
AC power supply cord
(included)
step
6 Preparing the remote control
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer’s instructions.
R6/LR6, AA
Insert so the poles (i and j) match those in the remote control.
Press in and lift up.
Replace the cover.
SC-PT760-960P-PC_Body2_Eng.fm Page 11 Tuesday, December 11, 2007 10:50 AM