Filter
Top Products
8
VQT4X66
8
Connections
1 Connect the FM indoor antenna (supplied) to
the speaker unit.
2 Connect the AC mains lead after all other
connections are completed.
≥ After connecting the AC mains lead to the mains socket, wait
for more than 15 seconds to turn on the Standby/on switch.
≥ When this system is turned on, the CD unit and the speaker
unit are connected wirelessly.
≥ If this system is turned on immediately after connecting the
AC mains lead, this system may turn off because the
connection between the speaker unit and the CD unit has not
been established. In that case, turn on this system again.
≥ When this system is turned on for the first time after
purchase, a message prompting you to connect a Bluetooth
®
device (“PAIRING”) is displayed. (l 16)
≥ This system consumes a small amount of AC power (l 28)
even when turned off.
≥ In the interest of power conservation, if you will not be using
this system for an extended period of time, unplug it from the
household mains socket.
≥ Tape the FM antenna to a wall or column in a position with
the least amount of interference. (Use an FM outdoor
antenna if radio reception is poor.)
1 Plug the audio cable (not supplied) into the
AUX jack.
Plug type: ‰3.5 mm stereo
2 Press [ , AUX] to select “AUX” and start
playback on the connected device.
To select the sound input level of the
external device
1 While in AUX mode, press [PLAY MENU] to
select “INPUT LEVEL” and then press [OK].
2 Press [3, 4] to select “NORMAL” or “HIGH”.
≥ The default setting is “NORMAL”.
≥ Switch the equalizer off or turn the volume of the external
device down to reduce the input signal. High level of input
signal will distort the sound.
≥ For details, refer to the instruction manual of the other
equipment.
≥ The cables and the devices are not supplied.
If the CD unit and the speaker unit are not
wirelessly connected, or the output sound is
interrupted, connect the both units with two audio
cables (plug type: ‰3.5 mm stereo, not supplied)
as illustrated below.
≥ We recommend you use cables of less than 5 m.
≥ If the cables are connected, the displays show
“WIRED MODE” and this system starts wired
communication. This system automatically
connects wirelessly when the cables are
disconnected.
Basic connection
Adhesive tape
(not supplied)
FM indoor antenna
(supplied)
To a household
mains socket
AC mains lead
(supplied)
Connect an external music device
(for AUX mode)
Connect the CD unit and the
speaker unit with cables (optional)
Audio cable
(not supplied)
Audio cable (not supplied)
SC-NE5GS~VQT4X66.book 8 ページ ２０１３年３月２５日 月曜日 午後３時４０分