Filter
Top Products
26
RQT9660
Advanced operations
Change the dual audio from main to secondary.
Confirm the digital audio output
setting on the connected TV or
player, etc. is set to “Bitstream”.
Press and hold [TV] for more than 2
sec.
While the indicator of the current
setting is blinking, press [TV] to
change the setting.
≥ The indicator for the current setting blinks for 10 sec.
≥ The setting works only when the dual audio is available
in the audio source.
≥ The setting is maintained until it is changed again.
≥ The same setting is used for all digital audio sources.
With this function, you can prevent sudden loud sounds.
The output will be reduced automatically when the input
exceeds a certain level.
Press and hold [INPUT SELECTOR]
on remote controller for more than 2
sec.
≥ The indicator for the current setting blinks for 10 sec.
While the indicator is blinking, press
[INPUT SELECTOR] to change the
setting.
≥ The setting changes each time [INPUT SELECTOR] is
pressed.
≥ The setting is maintained until it is changed again.
≥ Default setting of this function is OFF.
You can select different modes to suit the type of
connections which emphasis on connectivity or high
quality audio.
≥ Make sure that a Bluetooth
®
device is already paired
with this unit. (> 22)
Disable the Bluetooth
®
connection of
the device.
≥ “” indicator will blink slowly.
Press [LINK MODE, ] to display the
current mode.
≥ The indicator for the current setting blinks for 10 sec.
While the mode is displayed, press
[LINK MODE, ] to select the mode.
≥ The setting changes each time [LINK MODE, ] is
pressed.
≥ The setting is maintained until it is changed again.
Depending on your preference, It is possible to use only
the Dolby Virtual Speaker effect by turning off the 3D
surround effect and the clear-mode dialog effect.
Press and hold [TV] on the remote
control and followed by [VOL r] on
the main unit for more than 2 sec.
≥ The indicator for the current setting blinks for 10 sec.
While the indicator is blinking, press
[TV] to change the setting.
≥ The setting changes each time [TV] is pressed.
≥ This setting will be reset to on when this system is
turned off.
≥ When off is selected, the dialog effect level cannot be
adjusted.
Changing the dual audio
A : Main
B : Secondary
(SAP: Secondary Audio Program)
A, B : Main and secondary
Auto gain control
Dolby Digital indicator blinks:
Auto gain control is on.
PCM indicator blinks:
Auto gain control is off.
Bluetooth
®
communication
mode
MODE1: (Factory preset)
Emphasis on connectivity
MODE2:
Emphasis on audio quality
To turn off the 3D surround
effect and clear-mode
dialog effect
Dolby Digital indicator blinks:
3D surround effect and clear-
mode dialog effect is on.
PCM indicator blinks:
3D surround effect and clear-
mode dialog effect is off.
RQT9660~Body_mst.fm Page 26 Tuesday, March 6, 2012 10:32 AM