Filter
Top Products
Reference
27
VQT3Q59
≥ If the connections are correct, there might be a problem
with the cables. Redo the connections with different
cables.
≥ Check the audio output settings on the connected
device.
≥ If the HDMI 2 indicator flashes and there is no audio
output, try the following.
1 Turn the connected device off and then on.
2 Turn off this system, remove the HDMI cable, then
reconnect the HDMI cable and turn this system back
on.
The dual audio cannot be changed from main to
secondary.
If the audio received from the connected device is not
“Dolby Dual Mono” or the output setting is not “Bitstream”,
the setting cannot be changed from this system. Change
the setting on the connected device.
The volume is lowered when this system is
turned on.
If this system is turned off with the volume setting in the
greater half (above 50), this system will automatically lower
the volume to the middle (50) when this system is turned
on. (> 25)
The dialog is too persistent or the dialog does
not sound natural.
This system has a function to make the dialog stand out
when the volume is low. (> 25)
There is no audio.
The power of this system turns off
automatically.
(When this system detects a problem, a safety measure is
activated and this system automatically switches to
standby mode.)
≥ There is a problem with the amplifier.
≥ Is the volume extremely high?
If so, lower the volume.
≥ Is this system placed in an extremely hot place?
If so, move this system to a cooler place and wait a few
moments and then try to turn it on again.
If the problem persists, confirm the TV indicator and HDMI
2 indicator blink, turn the system off, remove the AC power
supply cord and consult your dealer. Please be sure to
remember the indicators that were blinking and inform the
dealer.
Indicator illumination
The indicators display the condition of this system by flashing. The indicator patterns illustrated below are
displayed during normal operational conditions. They do not refer to the indications of a problem. Refer to
“Troubleshooting” (> 26) if the indicators do not light as illustrated below.
Indicator Description
The indicators blink from left to right (i) or from right to left (s).
≥ When the speaker volume or the subwoofer level is adjusted (> 22)
The indicators blink simultaneously.
≥ When “MUTE” is on (> 22)
The indicator blinks for 10 sec.
≥ When the audio output mode is Multi-channel mode (> 23)
≥ When 3D surround effect and clear-mode dialog effect are on (> 25)
≥ When the dual audio setting is Main (> 25)
The indicator blinks for 10 sec.
≥ When the audio output mode is Auto mode (> 23)
The indicator blinks for 10 sec.
≥
When the audio output mode is 2ch mode
(> 23)
≥ When Dolby Virtual Speaker is on (> 25)
≥ When the dual audio setting is Secondary (SAP: Secondary Audio Program)
(> 25)
The indicators blink for 10 sec.
≥ When the dual audio setting is Main and Secondary (> 25)
The indicators blink for 10 sec.
≥ When the remote control code is changed (> 25)
The indicators blink once.
≥ When changing the setting (To turn off VIERA Link “HDAVI Control”, To reduce
the clear-mode dialog effect and To turn off the volume limitation) (> 25)
SC-HTB15PP_VQT3Q59_eng.book Page 27 Wednesday, June 8, 2011 3:33 PM