Filter
Top Products
23
RQT7696
The radio
Main unit only
1 Press [INPUT SELECTOR] to select “FM”
or “AM”.
2 Press [TUNE MODE] to select “MANUAL”.
3 Press [X TUNING] or [TUNING W] to
select the frequency.
Press and hold [X TUNING] or [TUNING W] until the
frequency starts scrolling to start automatic tuning. Tuning
stops when a station is found.
1 Tune to the station (‹ above).
2 Press [ENTER].
3
While “PGM” is flashing on the display
Press the numbered buttons to select a
channel.
Alternatively, press [X CH] or [W CH], then press [ENTER].
The station occupying a channel is erased if another station is
preset to that channel.
∫ FM frequency step
Main unit only
You can change the FM step. The step is factory-set to 0.2 MHz, but
you can change it to receive broadcasts allocated in 0.1-MHz steps.
1 Press [INPUT SELECTOR] to select “FM”.
2 Press and hold [INPUT SELECTOR].
After a few seconds the display changes to show the current
minimum frequency. Continue to hold the button down. The
minimum frequency changes and the step is changed.
To return to the original step, repeat the above steps.
[Note]
Any FM/AM frequencies preset in channels will be changed by this
procedure. Preset them again.
Use outdoor antennas if radio reception is poor.
≥Disconnect the antenna when the unit is not in use.
≥Do not use the outdoor antenna during an electrical storm.
Manual tuning
Presetting the channels one by one
PTY
DISC
SLEEP
TTL GRP
D.MIX
PROG.
RND
SEQ
S.S
R
TRC
K
CHA
P
P
D
PGM
RDS PS
Optional antenna connections
OPTICAL
IN
L
R
A
FM ANT
(75h)
AM ANT
LOOP
EXT
COMPONENT VIDEO OUT
(480P/480I)
YP
B
P
R
LINE
OUT
AUX
TV
AUDIO
IN
VCR
AUDIO
IN
S-VIDEO
OUT
VIDEO
OUT