Filter
Top Products
7
RQT7978
≥Use only supplied speakers
Using other speakers can damage the unit, and sound quality will
be negatively affected.
≥Set the speakers up on an even surface to prevent them from
falling. Take proper precautions to prevent the speakers from
falling if you cannot set them up on an even surface.
Main unit
[Note]
Keep your speakers at least 10 mm away from the system for
proper ventilation.
Center speaker
≥Vibration caused by the center speaker can disrupt the picture if it
is placed directly on the television. Put the center speaker on a
rack or shelf.
≥To prevent the speakers from falling, do not place directly on top
of the television.
Active subwoofer
Place to the right or left of the television, on the floor or a sturdy
shelf so that it won’t cause vibration. Leave 10 cm at the rear for
ventilation.
Caution
Do not stand on the base and
shake the speaker.
Be cautious when children are
near.
Notes on speaker use
≥You can damage your speakers and shorten their useful life if you
play sound at high levels over extended periods.
≥Reduce the volume in the following cases to avoid damage:
–When playing distorted sound.
–When the speakers are reverberating due to a record player, a
microphone (except [The[United[Kingdom,\Australia[and\N.Z.\), noise
from FM broadcasts, continuous signals from an oscillator,
test disc, or electronic instrument.
–When adjusting the sound quality.
–When turning the unit on or off.
≥Attach the speaker-cable stickers to make connection easier.
≥The terminals of the subwoofer have high output power. Carefully connect the speaker wires.
If irregular coloring occurs on your television
The supplied speakers are designed to be used close to a
television, but the picture may be affected with some televisions
and setup combinations.
If this occurs, turn the television off for about 30 minutes.
The television’s demagnetizing function should correct the
problem. If it persists, move the speakers farther away from the
television.
Caution
≥The main unit and supplied speakers are to be used only
as indicated in this setup. Failure to do so may lead to
damage to the amplifier and/or the speakers, and may
result in the risk of fire. Consult a qualified service
person if damage has occurred or if you experience a
sudden change in performance.
≥Do not attempt to attach these speakers to walls using
methods other than those described in this manual.
STEP3
Connecting speakers with the subwoofer
Click!
Sheet of speaker-cable stickers
Speaker-cable sticker
2 FRONT (R)
1 FRONT (L)
5 CENTER
4 SURROUND (R)
3 SURROUND (L)
ACTIVE
SUBWOOFER
White
Blue
Insert the wire fully.
Click!
[Note]
≥[HT840] [HT880] Even though the subwoofer shown is different, you can connect the speakers to the subwoofer in the same way.
≥Never short-circuit positive (i) and negative (j) speaker wires.
≥Be sure to connect only positive ([HT530]: white, [HT840] [HT880]: copper) wires to positive (i) terminals and negative ([HT530]: blue,
[HT840] [HT880]: silver) wires to negative (j) terminals. Incorrect connection can damage the speakers.
The illustration shows SC-HT530.
Speaker cables
[HT530]
≥3 kshort cables: For front and center speakers
≥2klong cables: For surround speakers
[HT840]
≥1kshort cable: For center speaker
≥2klong cables: For surround speakers
[HT880]
≥1kshort cable: For center speaker
[HT530]
Copper
Silver
[HT840]
[HT880]
Positioning/Connecting speakers with the subwoofer
HT530_880_840En.book Page 7 Wednesday, December 22, 2004 9:58 PM