Filter
Top Products
RQT8593
27
Using sound effects
This is one of the ways to get appropriate surround effects.
Preparation
Press [DVD].
∫ To adjust speaker level during play
[Effective when playing multi-channel audio or when Dolby Pro
Logic II or Sound Field Control (MOVIE, SPORT or MUSIC) is on,
and Surround Music is off.]
1 Press [CH SELECT] to select the speaker.
L
#C #R #RS #LS #SW
^-----------------------------------------------------}
SW: Subwoofer
≥You can adjust SW only if the disc includes a subwoofer
channel.
≥“SW” does not appear on the display and is not adjustable
when “ÎPLII” is lit.
≥“S” appears on the display when “MOVIE”, “SPORT” or
“MUSIC” is selected with Sound Field Control (➜ page 26).
In this case, you can adjust both surround speaker levels at the
same time using [3, 4].
S:
`
6dB to
i
6dB
2 Press [3] (increase) or [4] (decrease) to adjust the speaker
level for each speaker.
C, RS, LS, SW: `6dB to i6dB
(L, R: Only the balance is adjustable.)
≥To adjust the balance of the front speakers, while “L” or “R” is
selected, press [2, 1].
Adjusting the volume of each
speaker: Speaker level adjustments
1
While stopped and no on-screen display is shown
Press and hold [—TEST] to output a test signal.
≥To stop the test signal, press and hold [—TEST] again.
L: Front left C: Center R: Front right
RS: Right surround LS: Left surround
≥There is no output from SW (subwoofer) channel.
2
Press [VOLUME, r] or [s] to set the volume level
normally used for listening.
3
Press [3] (increase) or [4] (decrease) to adjust the
speaker level for each speaker.
≥Adjust the speaker levels to the same level as the front speakers.
C, RS, LS: `6dB to i6dB
HT440En.book Page 27 Thursday, December 29, 2005 7:56 PM