Filter
Top Products
9
RQTX1260
ENGLISH
Opening/Closing the
sliding door
Preparation
Press [Í] to turn the unit on.
For disc operations:
A While the sliding door is closed, press [CD <]
to open the sliding door.
For iPod/iPhone operations:
B While the sliding door is closed, press [iPod <]
to open the sliding door.
∫ Closing the sliding door
Press [CD <] or [iPod <] again.
≥ Keep fingers away from the sliding door when it is closing to avoid possible
minor injuries.
≥ Damage may occur if the sliding door is forced closed.
≥ Be careful of CD hitting the sliding door while being removed.
≥ The sliding door will not close if the docking switch lever is not returned to the
original position.
With this function the sliding door can be opened without
pressing a button. The sliding door will open or close by moving
the palm of your hand over the sensors on the top of the unit.
For disc operations:
Place the palm of your hand over sensor B and
then move it over sensor A.
≥ To close the sliding door, place the palm of your hand over
sensor A and then move it over sensor B.
For iPod/iPhone operations:
Place the palm of your hand over sensor A and
then move it over sensor B.
≥ To close the sliding door, place the palm of your hand over
sensor B and then move it over sensor A.
∫ To change the setting of the open/close sensor
The sensitivity of the sensor can be changed to increase or
decrease the activating area of the open/close sensor.
Press [OPEN/CLOSE SENSOR] repeatedly to
select “MODE 1”, “MODE 2”, “MODE 3” or
“OFF SENSOR”.
Select the mode that allows correct operation.
≥ Factory preset: “MODE 2”
≥ To turn the open/close sensor off, select “OFF SENSOR”.
∫ To change the sound effect settings of the
open/close sensor
1 Press [SOUND] repeatedly to select “BUZZER”.
2 Press [2] or [1] to select the following setting.
≥ A red light is lit from the position of the sensor. This is normal.
≥ The open/close sensor might be unintentionally activated if an object, hand,
part of your arm, pets or children move over the top of the unit.
≥ If the open/close sensor does not react, move the palm of your hand closer to
the top of the unit and change the speed that you move your hand.
≥ If the open/close sensor does not work, try changing the sensor’s setting. If it
still does not work, open/close the sliding door using the buttons on the unit or
the remote control.
≥ When the sensor setting is changed to “MODE 1”, move your hand closer
(approx. 3 cm (1
1
/8")) over the unit.
≥ The disc operation side of the sliding door will not open during CD playback
or pause.
Disc operations
1 Press [Í] to turn the unit on.
2 Open the sliding door. (> left)
3 With the label of the disc facing
towards you, tilt the disc into the
disc tray under the sliding door.
4 Place the disc onto the spindle in
the center and then push the disc
down until it clicks into place.
≥ Make sure that the unit does not fall when
inserting the disc.
5 Close the sliding door. (> left)
∫ Removing a disc
1 Open the sliding door.
2 Hold the center and the top right of the disc and pull the top
right of the disc to unlock it from the spindle.
3 Tilt the disc so as not to touch the sliding door or the lens and
remove the disc.
Opening the sliding door
[HC55] Open/Close sensor
AB
ンモュリヰ
ヷヰロヶヮユ
ヷヰロヶヮユ
LOW: Set the sound effect level to low.
MID: Set the sound effect level to medium.
HIGH: Set the sound effect level to high.
OFF: Turn the sound effect off.
Inserting a disc
SC-HC55_35-RQTX1260.book 9 ページ ２０１１年４月４日 月曜日 午後４時５０分