Filter
Top Products
4
RQT9648
4
Getting started
Making the connections
1 Prepare the setting stand.
2 Install the unit on the setting stand.
Align and put the unit on the setting stand, turn the
screw clockwise to secure the unit.
3 Connect the AC mains lead.
The system consumes approximately 0.2 W when it
is in standby mode.
Do not use an AC mains lead from other equipment.
Note:
• Do not sit on top of the unit.
• Some settings return to default when you disconnect
the system.
• These speakers do not have magnetic shielding. Do
not put them near TVs, PCs or other equipment easily
influenced by magnetism.
• Do not remove the speaker nets.
• Hold the unit firmly when moving it. Do not hold the
setting stand.
Preparing the remote control
Before using
Remove the insulation sheet.
Replacing the battery
Replace with a new battery (CR2025 lithium battery).
1 While pressing the stopper, pull out the
battery holder.
2 Insert a new battery with the (+) side facing
up.
3 Push the battery holder back fully.
For the United Kingdom and Kuwait
READ THE CAUTION FOR AC MAINS LEAD
ON PAGE 3 BEFORE CONNECTION.
To household
mains socket
CR2025
GT07E_en.fm Page 4 Thursday, April 12, 2012 1:16 PM