Panasonic SC-BTT466 Home Theater System User Manual


 
35
Advanced operationsReference
VQT5F60
Reference
Troubleshooting guide
Before requesting service, please perform the
following steps.
Unit does not respond to remote
control or unit’s buttons.
Disconnect AC power supply cord, wait 1 minute,
then reconnect AC power supply cord.
The following do not indicate a problem with
this unit:
Regular disc rotating sounds.
Image disturbance during search.
Image disturbance when replacing 3D discs.
Cannot eject disc.
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
j“00rEt” is displayed on the unit’s display.
3 Press [1] (right) repeatedly on the remote
control until “06FtO” is displayed on the unit’s
display.
4 Press [OK].
To return to the factory defaults.
¾ Select “Yes” in “Restore Default Settings” in
the Setup menu. (> 32)
To return all settings to the factory preset.
¾ Reset the unit as follows:
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
j“00rEt” is displayed on the unit’s display.
3 Press [1] (right) repeatedly on the remote
control until “08FIn” is displayed on the unit’s
display.
4 Press and hold [OK] for at least 5 seconds.
The remote control does not work properly.
¾ Change the batteries in the remote control.
(> 9)
¾ Depending on the condition of the unit,
[SELECTOR] and [ ] may not respond.
Display the HOME menu and try again.
The TV tuner mode is not displayed when the
TV is turned on.
¾
This phenomenon may occur, depending on the
TV setting, when “Quick Start” is set to “On”.
You have forgotten your ratings password.
You want to cancel the ratings level.
¾ The ratings level returns to the factory
defaults.
1 Turn the unit on.
2 Press and hold [OK], the yellow button and
the blue button on the remote control at the
same time for more than 5 seconds.
j“00rEt” is displayed on the unit’s display.
3 Press [1] (right) repeatedly on the remote
control until “03 VL” is displayed on the unit’s
display.
4 Press [OK].
Do you have the latest firmware installed?
Panasonic is constantly improving the unit’s
firmware to ensure that our customers are
enjoying the latest technology. (> 14)
4
Make the following checks and visit our
website for more information.
www.panasonic.com/support
Enter the model number.
4
Or visit our website to find a service center.
You can find a service center near you easily
on our website.
Other support information:
“Customer Services Directory (United States
and Puerto Rico)” (> 47).
General operation
SC-BTT466&465&405P-VQT5F60_mst.book 35 ページ 2014年1月17日 金曜日 午後5時56分