Filter
Top Products
38
VQT4D57
Enjoying sound effects
from all speakers
For more details on each setting, refer to “Sound
Settings” on the Option menu. (> 30)
1 Press [SURROUND].
2 Press [3, 4] to select “MULTI CH SOURCE”
or “2CH SOURCE”, and then press [OK].
e.g.,
3 While the selected mode is displayed
Press [3, 4] to select the desired setting.
(
>
30
)
∫ Adjusting speaker level during play
1 Press [CH SELECT] to activate the speaker
setting mode.
2 Press [CH SELECT] several times to select
the speaker.
≥ Press [2, 1] to adjust the balance of the
front speakers.
3 Press [3] (increase) or [4] (decrease) to
adjust the speaker level for each speaker.
s6 dB to r6 dB
1 Press [SOUND].
2 Press [3, 4] to select “2CH SOURCE” or
“ALL SOURCE”, and then press [OK].
e.g.,
3 While the selected mode is displayed
Press [3, 4] to select the desired setting and
press [OK].
Repeat this procedure if necessary. (> 30)
≥ The sound effects/modes may not be available or have no
effect with some sources.
≥ You may experience a reduction in sound quality when
these sound effects/modes are used with some sources. If
this occurs, turn the sound effects/modes off.
Speaker installation
option
Consult a qualified building contractor when
attaching the speakers to a wall. Improper
attachment may result in damage to the wall and
speakers and personal injury.
You can attach all of the speakers (except
subwoofer) to a wall.
≥ The wall or pillar on which the speakers are to
be attached should be capable of supporting
10 kg per screw.
1 Drive a screw (not supplied) into the wall.
A At least 30 mm
B ‰ 4.0 mm
C ‰ 7.0 mm to
‰ 9.4 mm
D Wall or pillar
E 5.5 mm to 7.5 mm
2 Fit the speaker securely onto the screw(s)
with the hole(s).
Use the measurements indicated below to identify
the screwing positions on the wall.
≥ Leave at least 20 mm of space above the
speaker and 10 mm on each side to allow
enough space for fitting the speaker.
Surround Effects
Sound Effects
Attaching to a wall
e.g., Front speaker
DO NOT DO
≥ In this position, the
speaker will likely fall if
moved to the left or right.
≥ Move the speaker so
that the screw is in this
position.
SC-BTT190GNGSGA-VQT4D57_mst.book 38 ページ ２０１２年１月１２日 木曜日 午前９時５９分